Breathe easy! No registration or passwords -- nothing to hack.
... and no maddening pop-up, sticky, or floating ads :-)

Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Meters per second to micro-inches per second




2006

I want to convert meters per second to micro-inches per second. What is the conversion factor.

Roger Straub




2006

The seconds have nothing to do with it in this case, Roger, so you're just converting meters to microinches. The two units are vastly different in scale, reminding me of a fraternity pledge project I had to do eons ago, i.e., to find the volume of the average human cranium in cubic parsecs.

Anyway, since a meter is 39.7 inches, it's 39,700,000 microinches.

Ted Mooney, finishing.com
Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA