Breathe easy! No maddening pop-up, sticky, or floating ads on this site :-)

Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
 
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Industry standard for cosmetics on clear chromate, aluminum




2006

I was wondering if there was a Industry Standard on Clear Chromate over Aluminum as far as appearance and scratches.

Lee P. Swearingen




2006

It would be the responsibility of the end-user to decide the cosmetic requirements of an item and a platers' job to comply with them.

Bill Grayson
metal finishing - San Jose, California




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA