Ted Mooney, P.E. RET
- Pine Beach, NJ
The authoritative public forum
for Metal Finishing since 1989
-----
Voltage Rating for Dielectric Test of a 3-phase 400 Hz PMG Stator, 30AWG Wound.
Electrical tests are widely used by OEMs, repair shops and motor and generator users to evaluate the condition of the electrical insulation in stator windings. These tests include hipot, insulation resistance, insulation power factor, surge comparison and partial discharge tests. To preserve the integrity of ML coating, what should the maximum voltage be for dielectric test of a three phase 400 Hz PMG stator wound with 30 AWG?
Igor Kulikovaerospace - Rockford, Illinois
1999
we need some documentation about A.C HIGH VOLTAGE TESTING EQUIPMENT , in order to realize a platform for dielectric tests.
housni bounouar- marakkech , morocco
2000
February 27, 2009
Hi, folks. Anyone is welcome to try to answer this one, but apparently it's veered a little off target for our target audience of industrial metal finishers :-)
Regards,
Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
Q, A, or Comment on THIS thread -or- Start a NEW Thread