"Smudge" on electrolytic tinplate

Related to incoming clean steel or...? All new wringer rolls, clean wash water, but comes and goes. Any suggestions? Easiest way to eliminate w/o going thru major changes (dropping tanks and rinsing etc...)? THANKS

Ian Hunter
US Steel - Gary IN USA
2005

Q, A, or Comment on THIS thread -or- Start a NEW Thread

No dead threads!
Your Q, A, or Comment puts this thread on The Finishing.com HOTLINE.

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: