
Thread 364/42
Plating on magnesium motorcycle covers
WE A LARGE JOB SHOP AND WANT TO PLATE ON MAGNESIUM MOTORCYCLE PARTS FOR SHOW. NEED A PROCESS THAT WORKS WELL AND IS TESTED AND USED EVERY DAY WITH GOOD RESULTS.
MIKE ARCH- NASHVILLE, TENN
2005
publicly reply to MIKE ARCH
Try looking up ASTM B480. The process is outlined there. Some mfgrs. do make a zincate for magnesium which is basically that which is described.
Gene Packmanprocess supplier - Great Neck, New York
publicly reply to Gene Packman
If you are a large job shop you must have some good and reputed suppliers. Why not asking them? They will surely have much more interest to give a good advise and full service than someone far away in front of his monitor answering posts for fun.
Guillermo MarrufoMonterrey, NL, Mexico
publicly reply to Guillermo Marrufo

Q, A, or Comment on THIS thread -or- Start a NEW Thread