No passwords, No popups, No cost
we earn from your eBay & Amazon purchases

Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Adver-
tise
Help
Wanted
Current
Q&A's
Site 🔍
Search
curated with aloha by
ted_yosem
Ted Mooney, P.E. RET
- Pine Beach, NJ
finishing.com -- The Home Page of the Finishing Industry


  pub
  The authoritative public forum
  for Metal Finishing since 1989

-----

Abrasion resistance of anodize coatings




Purchased anodized aluminum parts, when placed in a bowl feeder, the surface marred. What tests are available to test the integrity of an anodize coating?

w johnston
newtown, Connecticut
1999



I guess it is possible that the surface of the vibrator bowl is too hard for the anodized parts and is scratching them, W., but please see letter #1870 -- because my hunch is that the situation is just exactly the reverse. Regards,

Ted Mooney, finishing.com
Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
1999




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

Finishing
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g,
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"