Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Hard anodizing Aluminum with 1 mm thickness





2005

Dear sir
I'm an engineer and I work in alhashemi trading co. in Dubai UAE.
would you please describe me the process of hard anodizing the AL with about 1 mm thickness?or could you introduse me the Web site which help me?
best regards

Neda Izaddoust
alhashemi trading co. - Dubai, UAE



2005

Unless I did the math wrong, that sounds like about 20x the conventional thickness of hard anodizing, Neda. Please describe your situation and your needs rather than asking us to hypothesize on all of the ramifications of the general case of something so far out of the ordinary. Thanks.

Ted Mooney, finishing.com
Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey


none
finishing.com is made possible by ...
this text gets replaced with bannerText
spacer gets replaced with bannerImages



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA