Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





"How am I going varnish rusted steel?"



-----

2005

Dear Sir,
Your site has been very helpful for me up to now.
I am trying to rust a steel round stairs which leads to my upper floor. I am using vinegar and sea water and this is going right up to now. Could you please inform me how to varnish it after without to destroy the rust and to be able to touch it and stay clean. It is important for our clothes not to get rust when touch this stair.
Shall I paint using brush or spray. I do not want to destroy the powder type since which has been created.

Thank you for giving me the chance to ask a question.
Regards

Antonis Potamianos
hobbyist - Dallas, Texas



2005

You can use any good proprietary epoxy lacquer!

Good luck!

Goran Budija
- Cerovski vrh Croatia


none
finishing.com is made possible by ...
this text gets replaced with bannerText
spacer gets replaced with bannerImages



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA