No registration or passwords; no pop-up ads -- just aloha, fun, & answers.
(as an eBay Partner & Amazon Affiliate earns from qualifying purchases).
Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Advertise
 
Help
Wanted
Current
Q&A's
Site 🔍
Search
pub  Where the
world gathers for metal finishing
Q&As since 1989



-----

Ambienol....have you tried it and what happened.





I was wondering if anyone has had any experience with a product called Ambienol in use with their acid and what were your results. Thanks for any information submitted.

James D. Browning
- Oxford, Mississippi
1999



We've used Ambienol C in our 50% HCl ("muriatic") for a few years now. It is a good wetter and really helps to cut down on the fuming. Even if an acid is vented, a difference can be noticed. It also cuts the aggressiveness of the acid- it's actually possible to leave a steel part in for up to 2 hours with no etching. But you have to be careful if you're manually running racked parts through an Ambienol-wetted acid. Because it is a wetter, it will help to form large "bubbles" on racked parts. These bubbles can burst and will mist acid over anything in the vicinity...

Megan Pellenz
Megan Pellenz
- Syracuse, New York
1999


Mention has been made that the addition of a product surfactant called Ambienol C to HCl reduces the amount of fuming. Does anyone know where I can access this product for a trial basis. thanks

Louis Smith
- Warwick, Rhode Island
1999



Contact Metalline Chemical Corporation of Mequon, WI for your local Ambienol C distributor.

Megan Pellenz
Megan Pellenz
- Syracuse, New York
1999




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"