PEOPLE helping each other -- No AI, no cost, no reg'n, no damn popups
(As an Amazon Associate & eBay Partner we earn from qualifying purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

EDM tool for surface finish

2004

I need to EDM a custom carbide tool in order to achieve a 3.2 - 6.4 (mm) Ra finish, can someone help me on how deep and how much separation do I need to put on this tool? This will be used to machine Cast Iron.

Thanks in advance

Carlos Rdz.
Eng - Torreon, Coahuila, Mexico

Carlos,
Your question refers more to a machining operation and this forum deals more with finishing operations. Vendors of EDM machines, electrodes or peers with more experience in these matters can better help you, I guess. G. Marrufo-Mexico

Guillermo Marrufo
Monterrey, NL, Mexico
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: