Where the world gathers for
plating, anodizing, & finishing Q&As since 1989

-----

Inferior Surface Finish

2004

Dear Sirs,

When we compare our products which are powder coated with products available from USA, our smoothness of paint is far inferior to that of products available in the US. What could be the reason?

Sundeep Aggarwal
Handicrafts - Delhi, India

2004

Mr. Aggarwal,

Are you saying that you are comparing powder coated products that you are purchasing from two different suppliers, or are you an applicator and the paints you are getting produce different result?

Sheldon Taylor
supply chain electronics
Wake Forest, North Carolina

finishing.com is made possible by ...
this text gets replaced with bannerText

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: