Where the world gathers for
plating, anodizing, & finishing Q&As since 1989

-----

Minimize top dross in zinc pot

2004

Should I inject ZINC AMMONIUM CHLORIDE into zinc pot so that minimizing top dross (ZnO + Al2O3) ? To minimize top dross, please give me one advise.

DO CAO CUONG
hot dip galvanized - THU DAU MOT, BINH DUONG, VIET NAM

adv.
this text gets replaced with bannerText

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: