Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

HFO Burner Wind Boxes Material





2004

We use in our boiler 605 t/h 120 bar a corten steel as material of the wind boxes of the HFO fuel burners. The problem of this material that it has short live due to high temperature and harsh environment. Please advise me for a better material to extend the live of the wind boxes.

Iqbal Saied Alharbi
Boiler Maintenance Engineer - Jeddah , Western Province , Kingdom of Saudi Arabia



2004

SS-304 would be ideal material if this is a fabricated body. You can even think of lining the internal surface with a Refractory castable specially of the areas where there would be heat transfer by radiation.

VIKAS AGRAWAL
- Calcutta, W.Bengal, India.


adv.: ResinTech banner



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA