Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Gamma phase zinc coating on brass wires

2004

"The EDM Handbook"

on AbeBooks

or Amazon

(affil links)

We coat zinc on brass wires (0.20mm) for use in EDM machines. We want to know more about a galvanizing process by which we can galvanize brass wire to gamma phase so that the surface of the wire becomes hard but the body of the wire remains ductile - for better cutting speed of the wire in the EDM machine. We are already doing this but desire improvements.

Basantt Khaitan
plating shop - Jaipur, Rajasthan, India

Global Trade Network, Inc. is the exclusive license holder of Gamma phase technology currently used to manufacture the EDM wires.

Ramesh Malhotra
- Mason, Ohio
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: