The Last Stand of the web we knew & loved: no cost, no reg'n, no popups
As an Amazon Associate & eBay Partner: we earn from qualifying purchases

finishing.com -- The Home Page of the Finishing Industry

-----

Solutions to Problems with clamping extrusions for anodizing

Q. I am engineer for technical support in small extrusion company in Bosnia. Before few days we receive order for aluminium profiles. That profiles is very small, and we have problem in anodizing process. Now, we lose a lot of time in clamping profiles on carrier. I need any help to try to solve that problem. Please send me any idea about that problem. Thank you.

Jelenka Vitomir
engineer - Vlasenica, Republic Srpska
2004

A. Your question is a bit vague to me, Jelenka. You might try fiberglass C-clamps. If that is not a good answer, we'd need a deeper understanding of the problem. Thanks!

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: