No registration or passwords; no pop-up ads -- just aloha, fun, & answers.
(as an eBay Partner & Amazon Affiliate earns from qualifying purchases).
Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Advertise
 
Help
Wanted
Current
Q&A's
Site 🔍
Search
pub  Where the
world gathers for metal finishing
Q&As since 1989



-----

Brass plate 800 lb bell?




I am looking for a brass plater with the capability of plating an 800 poound bell. The bell is approximately 4 feet tall and 3 1/2 feet wide. The owner of the bell lives in Saling Michigan.

Jonas McCluskey
Plating Company - Jackson, Michigan
1999



- Dear Jonas , I would think that this is a perfect job for a "Brush plater". Best regards

John Tenison-Woods
John Tenison - Woods
- Victoria Australia
1999


John Tenison is correct that brush plating would work well on this project. The part can be done on site or in a shop, which gives you more versatility.

David Crocker
- Valencia, California
1999




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"