No registration or passwords; no pop-up ads -- just aloha, fun, & answers.
(as an eBay Partner & Amazon Affiliate earns from qualifying purchases).
Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Advertise
 
Help
Wanted
Current
Q&A's
Site 🔍
Search
pub  Where the
world gathers for metal finishing
Q&As since 1989



-----

Polishing a titanium bicycle frame




I am not a metal finisher by trade, profession or other. I am seeking technical advice on how to polish a 3al-2.5v titanium bicycle frame. I have found it quite difficult finding this information. If anyone out there could shine some light into this project of mine I would sure be grateful. Thank-you, Raul

Raul P [last name deleted for privacy by Editor]
non-commercial - Miami Beach, Florida
1999




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"