No passwords, no registration, no paywalls, no popups, no AI

As an Amazon Associate & eBay Partner we earn from affil links

finishing.com -- The Home Page of the Finishing Industry

Search our quarter-million Q&As

Home of the finishing HOTLINE since 1989

-----

Powder Coat Hooks Lose Conductivity

I am having Powder Coat build-up on the conveyor steel hooks that suspend the parts. Is there a way to keep the electrical contact area clean? Possibly the two mating areas having a knife edge or conductive tape that can be replaced. I would appreciate any suggestions.

Wray Wiley
Manufacturing Engineer - Edina, Minnesota, USA
2004

We shot blast all our hooks at regular intervals to overcome this problem. There are chemical cleaners (nasty stuff), and pyrolysis ovens (expensive), but we find blasting cheapest and easiest.

Geoff Crowley
Crithwood Ltd.
Westfield, Scotland, UK

2004

Sorry! Finishing.com is temporarily Read-Only.
Ted Mooney is retiring but I have several offers to take it over.
We're working hard to make sure we find it the best new home.

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: