No passwords, no registration, no paywalls, no popups, no AI

As an Amazon Associate & eBay Partner we earn from affil links

finishing.com -- The Home Page of the Finishing Industry

Search our quarter-million Q&As

Home of the finishing HOTLINE since 1989

-----

Need Sermagard on Small Screws

2004

I need a plater/finisher who applies Sermagard to small screws...less than 1/4" in Dia., less than 1 1/2" long. These will already have a .0002-.0003 of Zinc + Yellow. There will be about 5 different sizes/lots, weighing 500-1,000 lbs. per lot. Especially would like to locate someone with experience applying Sermagard to screws for Lennox/Heatcraft/ADP.

Gill Haden
Fastener Distributor to OEM's - Huntsville, Alabama

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

Sorry! Finishing.com is temporarily Read-Only.
Ted Mooney is retiring but I have several offers to take it over.
We're working hard to make sure we find it the best new home.

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: