Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Starvet Info Required





2003

We have just installed a Starvet tank in our plating bay, we are the 2nd installation in NZ and the first to have our product made in NZ (by Macdermid). I would appreciate a contact from someone using this product who may be able to give a little advice as we try to get the Starvet working properly.

Thank you,

Gavin Phillips
- Blenheim, South Island, New Zealand



2003

Are you still having problems? And exactly what is the problem with the Starvet process? World-wide we, MacDermid, have many people that know this process. I can direct you to the proper individual.

Tony Varuolo
- Waterbury, Conn, USA

adv.:   
anoplex banner



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA