Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Advice on pre-treatment on powder coating





2003

I have recently started up a small powder coating department within my steel fabrication company and would like to know what the best manual degreaser and pre-treatment to use on aluminium and what guarantee can I give to my customers on the life of the powder coating.

Many thanks,

Eathan Danby
- Leeds, Yorkshire, England



2003

Hi Eathan,

The best pretreatment scenario for aluminum is to apply a chromate conversion coating. Without knowing the details of your setup or its limitations, I will leave you with that generic process.

As for the life of the powder coating, you should consult your powder coating supplier.

George Gorecki
- Naperville, Illinois


none
finishing.com is made possible by ...
this text gets replaced with bannerText
spacer gets replaced with bannerImages



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA