Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Deburring small stainless and titanium parts

I am interested in information on deburring small stainless and titanium parts. Does anyone know of any conferences and/or seminars that would help me?

Harv Hornung
- Clarence, New York
1998

Mr. Hornung,

If its a seminar you're after, check with SME (Society of Mfg. Engineers). They do a 2-3 times/year seminar on Mass Finishing. I've been to it and it is a good overview on what you are trying to learn. You can contact SME at their customer service center. They should be able to help. Good luck.

Dan Regan
mechanical prep specialist - Cinnaminson, NJ
1998

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: