People helping each other -- No AI, no cost, no reg'n, no damn popups
(As an Amazon Associate & eBay Partner we earn from qualifying purchases)

finishing.com -- The Home Page of the Finishing Industry

Thread 22/05

Electroforming Magnetic materials

I am interested in learning if anyone has done any electroforming of magnetic materials (in the range of 6-8 mils). Are there any alloys possible, or other materials? Thanks.

Patricia J. Frisch
1998
publicly reply to Patricia J. Frisch

Yes, Ms. Frisch, there are a number of magnetically hard and magnetically soft metals and alloys that can be plated. The MFIS CD-ROM showed more references than I had time to look up, probably 50 good references. Are you looking to make a permanent magnet or something softer?

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
publicly reply to Ted Mooney

Where could I get a copy of the MFIS CD-ROM, and how much does it cost?

Patricia J. Frisch
1998
publicly reply to Patricia J. Frisch

~~Finishing.com now distributes this, and you can order on-line. Current cost is $295.~~

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2002
publicly reply to Ted Mooney

Ed. note 2008: Finishing.com no longer handles the CD-ROMS because it became an on-line service. Look up "Metal Finishing Information Service" in England.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: