Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





"Spray Pyrolysis Nozzles aren't giving uniform film"



-----

2002

I'm looking for a spray nozzle for spray pyrolysis deposition. I'm looking to deposit small samples 1 cm in diameter. I have tried several nozzles but have not achieved a nice uniform film. Any suggestions?

Thanks,

Alan Kleiman
- Santa Barbara, California



2002

Are you talking about thermal spray or flame spray or High Energy Plasma or dual arc or D-gun or what? "What equipment including current nozzle?" is required for anyone to answer your question. What metal are you spraying onto what substrate metal?

James Watts
- Navarre, Florida


none
finishing.com is made possible by ...
this text gets replaced with bannerText
spacer gets replaced with bannerImages



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA