Where the world gathers for
plating, anodizing, & finishing Q&As since 1989
-----
RMS Units
2002
What are the units of measure used for RMS? Are they millionths of inch or something else? And is the reading the rugosity Rq obtained from a rugosimeter?
Giovanni M. Ciriani
Promotion - Altavilla, VI, Italy
2002
RMS results are in Microinches or Micrometer (micron). Rq is the RMS surface roughness parameter. Bill
Bill Boatright
- Raleigh, North Carolina
finishing.com is made possible by ...
this text gets replaced with bannerText
Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.
If you are seeking a product or service related to metal finishing, please check these Directories: