No passwords, no registration, no paywalls, no popups, no AI

As an Amazon Associate & eBay Partner we earn from affil links

finishing.com -- The Home Page of the Finishing Industry

Search our quarter-million Q&As

Home of the finishing HOTLINE since 1989

-----

Milling of Stainless Steel

Which grade of austenitic stainless is easiest to machine.

Jerry Schwartz
- fabricators
1998

1998

Jerry,

Please visit www.ssina.com/. There's a special hotline number to call should you have further questions.

Michael Liu Taylor
specialty stainless steel distributor - Dallas, Texas

1999

I'm interested in speeds and feeds on roughing and finishing of 304 s.s. The part I'm doing is 2" thick 44.5 O.D. 27.625 I.d. has a 15 degree taper on outside edge. using a 1" roughing endmill 1.75 finish endmill and need to know how much of a cut I should be taking at a pass. some has .400 rough stock. part is torched cut.

mike hatfield

Sorry! Finishing.com is temporarily Read-Only.
Ted Mooney is retiring but I have several offers to take it over.
We're working hard to make sure we find it the best new home.

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: