Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





Yellow Iridite Touch-Up



-----

 

I need to "Touch-Up" several small surfaces on an Aluminum part which has a Type 1, Cl yellow Iridite coating. The original coating has been rubbed off due to some assembly and inspection procedures. Is there a product available?

Dan Bellemore
- Dover, New Hampshire, U.S.A.



 

Search this site with words, "touchup pen" and such.

tom pullizzi animated    tomPullizziSignature
Tom Pullizzi
Falls Township, Pennsylvania


none
finishing.com is made possible by ...
this text gets replaced with bannerText
spacer gets replaced with bannerImages



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA