finishing.com -- The Home Page of the Finishing Industry
Serious Education & the most FUN
you can have in metal finishing smiley

No popups, spam, registration or passwords
HomeFAQsSuggested
Books
Help
Wanteds
Advertise
on this site
FORUM
current topics
topic 11158

Autoclave finishes


 

We are designing a surgical instrument (surgeon drill, not the drill bit) that could either be fabricated from aluminum or stainless. The mechanical requirements are minimal but the aesthetic finish and durability from autoclaving is very important. We are looking at chromium plating and chromium nitride. Any suggestions or concerns.

Jim Tappel
- Evanston, Illinois, USA



If you have a question in mind which seems off topic, please Search the Site

ADD a Comment to THIS thread START a NEW threadView CURRENT TOPICS

Disclaimer: It's not possible to diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations may be deliberately harmful.

  If you need a product/service, please check these Directories:

JobshopsCapital Equip. & Install'nChemicals & Consumables Consult'g, Train'g, SoftwareEnvironmental ComplianceTesting Svcs. & Devices


©1995-2018 finishing.com, Inc., Pine Beach, NJ   -   About finishing.com   -  Privacy Policy
How Google uses data when you visit this site.