OPTIONAL CYCLIC CORROSION TEST CHAMBER CYCLES
HUMIDITY CYCLE
Controlled Humidity Cycle*
- A solid-state humidity sensor reads the current humidity condition and compares that to the humidity set-point in the controller.
- The mechanism used to control the humidity moves chamber air via a blower motor and passes it over a heater coil in the bottom of the chamber with an atomizer nozzle fogging into this air stream.
- As humidity is needed, the controller pulses the atomizer nozzle on and off while recirculating the air flow.
SPRAY CYCLE
Solution Spray Cycle*
Solution is taken from the holding tank via a solution pump. This solution is driven through a spray bar header inside the exposure zone, and onto the parts by multiple spray nozzle.
IMMERSION CYCLE
Immersion Cycle*
A series of valves, float switches and a pump move solution from a heated holding tank into the exposure zone via the chamber drain. Once this cycle is over, the process reverses and moves the solution out of the exposure zone and back into the holding tank.
*Optional
Auto Technology Cyclic Corrosion Test Chamber:
Cyclic Corrosion Test Chamber - Back to Auto Technology
Site design & maintenance by finishing.com, inc.