No passwords, No popups, No cost, No AI
we earn from your eBay & Amazon purchases

curated with aloha by
ted_yosem

Ted Mooney, P.E. RET
- Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Soft anodize vs. bad seal

Q. We are having an issue with clear anodized bars that are passing the ink seal test but feel sticky and when hot water hits them they get an almost white appearance. We have been told this is soft anodize but our current supplier does not know what this is or how to test for it? How do we identify this condition and is there any literature we could get on this or a test facility we could send the bars too?

Thanks,
Ryan Breckenridge

Ryan Breckenridge
- Columbia City, Indiana
September 25, 2012

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: