HOME FAQs BOOKS JOBS: Help Wanted Suggestions you are here: Hotline/Forum => Letter 53248

Need small plating rectifier

October 7, 2009

Need small rectifier 3 Amp minimum for micro-plating.
Currently using manual dial power supply from Technic.
Would like a programmable supply that could be linked to a PC.
Need to control +/-1 milli-Amp
Thanks.

Wayne Wozniak
Plating Shop - Prescott, AZ, USA
^- Privately contact this inquirer -^

----
Readers: This site is made available for camaraderie & technical info exchange by our supporting advertisers, and they will contact the inquirer privately regarding their commercial needs. Please offer comments on any technical issues, but not sourcing suggestions or testimonials. Thanks!

ANSWER or FOLLOW UP POST an unrelated QUESTION HOT Topics

Disclaimer: It is not possible to diagnose a finishing problem or the hazards of an operation via these pages. All information
presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The
internet is largely anonymous; some names may be fictitious and some recommendations may be deliberately harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: