Letter 39077

Custom etching of gun barrels [Oklahoma] 

January 16, 2006

I am a Jewelry designer and student metalsmith. I have a client that has asked me to etch a saying into a gun barrel for him. I have seen pieces that have been etched before, but I am not sure if standard acid etching was used or if something else is required? As I am new to this arena, I am searching for some more experienced advice before I under take this project. Thank you for your assistance.

Me Lissa Lansford
Jewelry Designer - Duncan, OK, USA


February 9, 2006

IF YOU WANT SOME WRITING OR SMALL DRAWINGS YOU CAN USE STENCIL ,A FELT PAD SOAKED WITH SOME KIND OF ACID ,AND A SMALL AC OR DC POWER UNIT.GOOD LUCK.


Cair Shishani

aircraft maintenance - Abu Dhabi, UAE


Dear Reader: please choose what you want to do--

I want to answer or follow-up on this subject publicly (in non-commercial fashion).
 
My company is a supporting advertiser at finishing.com and we want the contact information to reach the inquirer privately.
 
I want to post a new question or inquiry of my own on a different subject.
 





     

 Save This Page (why?)    -    Home    -    ©1995-2008 finishing.com