No passwords, no registration, no paywalls, no popups

As an Amazon Associate & eBay Partner we earn from affil links

finishing.com -- The Home Page of the Finishing Industry

Search our quarter-million Q&As

Home of the finishing HOTLINE since 1989

-----

Bond building between stainless and carbon fiber panel

I would like a recommendation on how to etch 300 series stainless steel, that will be bonded to carbon fiber honeycomb panel. We currently use Epo-bond 420 adhesive. After etching and process shear specimens are produced. The bonding surface is 1 inch in diameter and .024 thick. This surface need to produce about a 2,000 pound load. Any suggestion will be appreciated.

Bob Waits
Manufacture of areospace fasteners - Riverside, California, USA
2004

Sorry! Finishing.com is temporarily Read-Only.
Please maintain your bookmarks! Although Ted Mooney is retiring, finishing.com is not!
It will have a new owner/curator very shortly!

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: