Letter 20053

Rz measurements to Rms measurements  

+++

I'm looking for information for converting surface finish specifications measured in "Rz" to those measured in "Rms". This would be mainly on steel parts. Thanks for the help.

Kay Kucharik
- Solon, OH, USA


+++

Rz is the same as RMS; however, the Rz spec designates a specific number of ridges and valleys (5) to be traversed by a profilometer.

AF Kenton
Nova Finishing Systems Inc.

Huntingdon Valley, PA


Dear Reader, please --

Answer or follow-up on this subject (in non-commercial fashion).
 
I want the contact information to reach the inquirer privately.
 
Post a new question or inquiry on a different subject.
 


Legal disclaimer boilerplate button

List of Directories
Jobshops Directory button Environmental Directory button Equipment Directory button Consultants Directory button Chemicals Directory button Test Directory button Help-Wanted Directory button About Advertising button Classifieds Directory button Booklist button

 

Link to Del.icio.us button Save This Page (why?)    -    Home    -    ©1995-2009 finishing.com