Letter 39088

Sandblasting WC-Co inserts before coating [Czech Republic] 

January 20, 2006

We have a discussion whether a providing of sandblasting WC inserts before CVD coating is necessary. We do sanblasting because of a few reasons: splinters of inserts made by pressing, reamining Co phase on surface of inserts, we are not sure about some residual stresess after sintering which sanblasting can partly remove. The main discussion is about if we should provide sanblasting of remaining Co phase on surface of inserts before CVD coating. Do we need to do that? Thank you.

Stanislav Berger
powder metallurgy - Czech Republic

I want to answer or follow-up on this subject publicly (in non-commercial fashion).

 

My company is a supporting advertiser at finishing.com and we want the contact information to reach the inquirer privately.

 

I want to post a new question or inquiry of my own on a different subject.