HOME FAQs BOOKS JOBS: Help Wanted Suggestions you are here: Hotline/Forum => Letter 792

Stripping of Electroless Nickel from Neodymium

We have been asked to strip and replate some electromagnets manufactured from Neodymium (NdFe). These magnets were electroless nickel plated by another firm and are now peeling. Our concern is whether or not this material (NdFe) might be damaged during the stripping process. What stripping solution might be employed?

Alan Cooper
- Dallas, Texas

---

I have stripped rare earth magnets in a two part electroless Ni strip , without any ill effects. Just make sure it's in a non-magnetic tank . The strip was at 60 c and is immersion type from a local supply house (possibly Udylite on your side ) .

Dave Brackenridge
aerospace plating - Germiston, South Africa

Please also see our FAQs on Stripping of Electroless Nickel, Alan, which may be of some help. Good luck.

Regards,

Ted Mooney, P.E.
finishing.com
Brick, New Jersey

ANSWER or FOLLOW UP POST an unrelated QUESTION HOT Topics

Disclaimer: It is not possible to diagnose a finishing problem or the hazards of an operation via these pages. All information
presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The
internet is largely anonymous; some names may be fictitious and some recommendations may be deliberately harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: